Skip to main content

Set-up Guide — Solo+ Telemetry Unit

Sumaiya
Updated

Welcome to your Solo+ set-up guide. 

The Solo+ is a stand-alone, low-cost and compact platform for remote monitoring and single point control applications. It comes with an integrated lithium battery. It can be powered via a solar PV panel or via mains power with our provided power adaptor. 

Below is a guide of the components of the Solo+ Module:

Solo-plus-components.jpg

 

sp-antenna-port.jpg

 

 

For a quick set-up follow the steps below:

  1. Check if you have all the parts: Your full solution will consist of the Solo+, cellular antenna, solar panel (optional), and one or two devices that will be connected to the Solo+ via its ports. 
  2. Record the serial number of your Solo+ unit located on the inside of the enclosure door (see diagram above). 
  3. Register the product:
    • If you already have an Observant Global account, you can follow the steps here to add the new equipment to your portfolio.
    • Otherwise, reach out to our Support team on 1300 224 688 or email helpdesk@observant.net and we'll help set things up on Observant Global and/or Jain Logic.
  4. Prepare for Installation:
    • Location: For the solar panel to generate sufficient power (especially during winter), it should face true south when north of the equator or true north when south of the equator and have an unobstructed view of the sun throughout the day. To allow the radio communications to operate effectively, the Solo+ should also be situated away from large metal structures, like sheds and windmills. If such structures are unavoidable, best results are obtained when the Solo+ is mounted on the very top of the potential obstruction.
    • Pre-cabling: Consider the routing and protection of equipment cables prior to installation. Cable is best protected above the ground by the use of rigid electrical conduit (20 or 25 mm works best). If the rear entry cable options are being used, cabling must be laid prior to the installation of the mounting post, extended up and through holes drilled in the post. 
  5. Install the hardware: Select the product type and mounting style from below
  6. For other devices, see its specific Technical Note. 
  7. Make sure all devices are online in Observant Global.
  8. Register for SMS and email alerts as described here. 

If you have any issues with the above process, reach out to our support team: 

Australia

Phone: 1300 224 688
SMS: +61 451 562 280
Email: helpdesk@observant.net

United States

Phone: (559) 485 7171
Email: helpdesk@observant.net

 

Powered by Zendesk